Movie Dalek Domelight Beaker 3D Scan 1.0.0

I had this file printed up on a UV cured resin printer, then pressure molded and cast it in a red tinted clear polyester resin. A lot of hard work, but the results are pretty amazing. If you could get it printed in a red, blue or yellow UV resin, then this is the way to get a very difficult part to find for your Movie Dalek build.

The ring at the rim of the beaker was to trap air bubbles in the mold and was cut away for use.

I had one printed off using a 3D Printer, and I'm gonna make a silicone mould of it so that I can quickly and relatively easily cast a couple plus any spares I might need. If the person who created this file is reading this, I'd love to know if you'd be down to potentially share profits from selling resin cast ones from my mould.  @audrey2  (It would probably be split 3 ways- Me who is doing the casting, my pal who printed the thing, and you who created the file in the first place.
Lemme know what you think, if there are any moderators reading this who could give me some tips as of how to go about selling through here too that'd be ace!