Jump to content

  • 0

Mk 3 Neck Ring Dimensions


Yorkyone
 Share

Question

Can someone advise me on neck rings please the MK 3 plans show the OSD and ISD measurements which to my understanding would make the rings 102mm in width , looking at pictures this can't be right or can  it ? 

Edited by Yorkyone
Not enough info
Link to comment
Share on other sites

4 answers to this question

Recommended Posts

  • 0

Bec is correct. The dimensions are diameters, so run the entire length of the circles. 

 

If (in your mind) you place the small circle over the large one, it will drop inside with space all around the edge. From left-to-right (say) you'll see 51mm of the large circle, then the smaller circle, then another 51mm of large circle on the other side.

 

What you've doing is adding 102 all the way 'round. ;)

  • Like 1
Link to comment
Share on other sites

  • 0

Thanks John. You answered it much better (as always) than my COVID brain and 1am posting could. 

 

Diameters. 

  • Like 1
Link to comment
Share on other sites

  • 0

Thanks to John and Bec Weir , School boy error I was getting my Circumference Diameter and Radius mixed up and not thinking it out properly DOH .

  • Like 2
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Answer this question...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...

Important Information

By viewing this site you accept our terms, conditions and privacy policies.