About This File
Second published attempt at anything like this, for 3D printing so please be gentle.
NOTE The screenshots show some pieces that have been printed unsanded & untrimmed & they also show cages V1.99 & V2 (The only part that is constant in both is the top ring), from the test fitting a roll back to V1.99 for the supports & base may be required for a deeper recess of 3mm.
The Top ring takes about 30 - 40 minutes on a Replicator 2 at Highest Quality settings.
A support piece takes about 32 minutes on a Replicator 2 at Highest Quality settings, these could be multiplied up to the required 8 for the output file.
The base will take about 3 hours on a Replicator 2 at Highest Quality settings.
It is suggested that a hot pin be pressed through the build material using pliers & suitable heat source for each support at the top & bottom rings after gluing for additional strength.
Despite various efforts a one piece print has not gone smoothly so still a kit of 6 parts not including Moflash lens, if a one piece is successfully produced, the file will be added as a compliment.
Constructive feedback welcome.
What's New in Version V1 See changelog
Released
- Each support has a 1mm extrusion to fit into 1mm recess at 90 degree intervals on the upper & lower rings.
- Three prototype files for a cage support with small credit text, top & bottom rings.
- Two small pilot holes based on best guess for countersunk Moflash lens screw holes if required, contemplating fixed bolt hidden under support.
- Moflash lens should hopefully fit flush into the cage base.
