About This File
Hey guys.
This is a STL file of the Imperial Dalek eyeball. It's in two halves that need to be printed and glued together.
It is a pair of STL files. They are much larger than normal as I have found issues with low resolution geometry making the prints come out with hard edges. If this is too much geometry I will remodel and upload again.
The front of the eye isn't as deep as the original prop, because it makes adding the front much harder! However I could do that variation if someone was keen.
The front of the eyeball itself is slightly rounded off as per the original, rather than being dead flat.
The rear of the ball has a nice flat section for tube to sit flush against, as well as a pilot hole included for drilling a central hole.
I haven't printed this file yet, but intend to tomorrow!
EDIT. The rear of the eyeball has a hole in he model. I have fixed the model, but not uploaded yet. This will be fixed soon.
EDIT- The previous upload didn't include the front of the eye. I only just saw a message about it then. (4th March 2016.)
What's New in Version 1.1 See changelog
Released
No changelog available for this version.
