NSD Eyestalk Pivot 1.0.0

I am printing this now, thanks.

I'm curious how to move the eye up and down.  The rear hole is smaller than the other threaded rod, so were you also planning on using that there, or something else?

Thanks again

I hope this picture helps you understand the installation. This is the first time I have tried a reply on my phone. If it does not work I will send you more info when I get back to my puter 

cdngoose

Great.  thanks.  I could sort of see that on some of your other pics, but that makes it very clear now

I have it attached to my threaded bar (and eye) and have it all wired up now
But, I have another question for you.  I still haven't got my dome pulled yet, but was wondering if the slot for the threaded bar nut shows outside the dome?

Thanks

Chris 

I tried to print this a couple times, but for some reason shortly in my printer stops extruding. Any ideas? Here's a picture of what completed. The printer keeps going, but no filament is extruding. 

@Arjaytee21 Your problem might get more attention if you post about it here

Thank you!