NDP Neck Rings 1.0.0

I created these files for Orin - my NDP Dalek build.  All measurements were taken from the PDF plans.

You need to print 12 of each file. I used PLA with 1mm wall thickness and 10% fill, but I would advise to go thicker - maybe 1.5mm, as the parts will warp under direct sunlight. Alternatively, try using ABS, which is less sensitive to ambient temperature.

For assembly, start at the bottom with Layer 1, then build up as follows:  Layer 2 base, Layer 2, Layer 3 base, Layer 3, Layer 4 base, Layer 4.  I added some strength by offsetting each base layer so that the joints did not all align vertically.