About This File
The dome is based on the Version 3.1 Movie plans (so the eye slot is higher than other classic domes), though the negative and back half files are consistent with other classic domes dimentionally. You could just print two back halves if you do not want a movie dome and cut the eye slot yourself. I would advise you consult the dome dimentions in the Version 3.1 Movie plans and compare them against the dimentions of your own plans if you are building a different classic dome.
This is a 3D printable Dalek dome model that has a curved eye slot rather than a rectangle extruded one making it more accurate to the real thing (It took quite a while to figure out how to make a hole based on a curved measurement in CGI). The front and back halves are provided, but you will have to slice it up if the model is bigger than your printer's build volume. The skinny dome is half an inch (1.27cm) thick and the normal one is one inch (2.54cm) thick. There are lower poly and higher poly (HD) variants of most files. A negative of the dome is also included for you want to use however you wish.
Edited by Omeganinjaboy
clairification on dimentional accuracy
What's New in Version 1.1.0 See changelog
Released
There is now a skinny variant which is half an inch (1.27cm) thick (the previous one was one inch (2.54cm) thick). Also, the skinny variant now has pre-split front and back half files. I have made HD versions of all STL files :)!! (I can go more high poly if necessary so tell me below)
Recommended Comments
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.