About This File
Eyestalk for my uploaded eye STL's.
Print Eye stalk bottom and eye pivot in the orientation it's presented in WITH supports, at least 20% infill and three perimeters is good.
No supports required for eye stalk top, it's been tested with the properly sized transparent acrylic tube which fits perfectly and has no play.
No glue required, just an M10 thread bar with two nuts for top and bottom.
Fire me a PM if you have an questions!
What's New in Version 1.0.0 See changelog
Released
Better tolerances
Recommended Comments
There are no comments to display.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.