About This File
NB: Single zipped folder or 6 individual files - your choice
So I wanted a light cage that did not show screws when assembled and came up with this solution.
It's essentially a remix of @Ultrastar Light cage with the following modifications.
- Added thread to the lower part of the cage plus the inner part of the threaded piece to be attached to the Dalek head
- The hole for the base and top is slightly larger to make screwing around the cage easier
- no change to his support
In this file I also included the surround part I did for my bulb using a trailer light. The spring from the light lid holds it in place to the lower part so no attachments required.
I used a Ping Pong bulb inside the moflash. so you may want to use some hot glue to secure that part.
The lower part has indentation to allow for my trailer base, if you don't need that, that part is low enough that should not be seen in your cage.
Enjoy
P.S. You will need to rotate a few pieces for print. support needed for some parts depending on your printer calibration.
What's New in Version 1.0.0 See changelog
Released
No changelog available for this version.