About This File
NB: Single zipped folder or 6 individual files - your choice
So I wanted a light cage that did not show screws when assembled and came up with this solution.
It's essentially a remix of @Ultrastar Light cage with the following modifications.
- Added thread to the lower part of the cage plus the inner part of the threaded piece to be attached to the Dalek head
- The hole for the base and top is slightly larger to make screwing around the cage easier
- no change to his support
In this file I also included the surround part I did for my bulb using a trailer light. The spring from the light lid holds it in place to the lower part so no attachments required.
I used a Ping Pong bulb inside the moflash. so you may want to use some hot glue to secure that part.
The lower part has indentation to allow for my trailer base, if you don't need that, that part is low enough that should not be seen in your cage.
Enjoy
P.S. You will need to rotate a few pieces for print. support needed for some parts depending on your printer calibration.
What's New in Version 1.0.1 See changelog
Released
Change is only to the "Base w thread Inner"
Changes are:
- inner wall of thread Inner is now a bit thicker wall for better strength. it is also now snog with the diameter of the Moflash ensuring it is center in the light cage, and
- also made inner hole on base a bit wider so that screw holes to attach the base to the dome would be less close to the edge if aligned with the Moflash.
Zip file also has the change
Recommended Comments
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.