About This File
This is a jig I made to drill a pilot hole in a 10cm gazing globe. The globes I used were Rome brand purchased thru Amazon. Each had a single hole already drilled. This jig allowed me to drill a matching hole directly opposite.
The base has leaves which can be clamped to the drill press table. It also has a peg which fits the existing hole in the globe. I clamped down the base, fitted the globe to the pin in the base, pushed the cylinder down over it and then the lid. The lid has a center hole.
There's also test cylinder file which is only 5mm tall. If you want to use this jig I suggest you first print the test cylinder and make sure it is the right size for your globe. It should fit very snugly.
Recommended Comments
There are no comments to display.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.