Jump to content

Please Register An Account

Shawcraft Mk1 & 2 TV Dalek Collar Templates 3.0.1

   (1 review)
John
 Share

1 Screenshot

About This File

Printable templates for the upper and lower collars for the Shawcraft Mk1 and Mk2 TV Dalek.

Note that the collars are designed to be compatible with the Version 3 plans and above, though they should also work reasonably well with the earlier plans.

The PDF is meant to be printed with tiling enabled so that it is printed over several sheets of paper. Ideally, crop marks should also be enabled so that the sections can be accurately re-assembled. The sheets can then taped together and the finished collars transferred onto card for test fitting. Once any adjustments are done, the card templates can be used to transfer the shape to the final collar material, for cutting.

What's New in Version 3.0.1   See changelog

Released

DFX file added for CNC use.

 Share
Previous File Imperial Dalek Shoulder Base Template
Next File 2005 (New Series) Dalek Shoulder Base & Layer Template

User Feedback

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest

  • This will not be shown to other users.
  • Add a review...

    ×   Pasted as rich text.   Restore formatting

      Only 75 emoji are allowed.

    ×   Your link has been automatically embedded.   Display as a link instead

    ×   Your previous content has been restored.   Clear editor

    ×   You cannot paste images directly. Upload or insert images from URL.

    ×
Dave S.

Dave S. 23

   1 of 1 member found this review helpful 1 / 1 member

Hi, I've just downloaded the template and printed it (I didn't know my printer could print this way!). Unfortunately, the printout is apparently not the correct size. I have attached a photo of my scale rule next to the size check box which shows the check box being smaller than it should be i.e. just under 9mm instead of 10mm as marked on the template. My printer won't allow any scaling when I print in sections, so can anyone advise please? If I use the template as printed, it will be too short. The depth may be ok as I don't think it would be all that noticeable.

Dave S.

Collar print scale.jpg

Response from the author:

Without knowing more about the hardware, software and OS you're using, it's difficult to say.

 

There may be a means of calibrating the printer or alternative software/drivers that will allow for scaling when tiling.

Link to review
×
×
  • Create New...

Important Information

By viewing this site you accept our terms, conditions and privacy policies.

  I accept