About This File
These are the DXF files I've made to cut out my parts [from steel]. The back panel and the top and bottom frames were too big to fit onto the steel I could afford to buy so they are split into several chunks.
SHEET_1.dxf - SHEET_5.dxf are the nested parts layout to fit all skirt panels onto 5 24 in. x 48 in sheets. The back panel is split in two to allow it to fit, the top and bottom perimeter frames are split into four for the same reason.
The holes for the hemis are only there for alignment and to lighten up the skirt a bit.
What's New in Version 1.0.0 See changelog
Released
No changelog available for this version.